SYSVOL Migration Series: Part 3 – Migrating to the ‘PREPARED’ state


Previous articles in this series contained an introduction to the SYSVOL migration procedure and explained how the Dfsrmig.exe tool can be used for SYSVOL migration. Keeping this background information in mind, we’re now ready to start the actual SYSVOL migration process. This article explains how to migrate replication of the SYSVOL share to the ‘PREPARED’ state. If the term ‘PREPARED state’ draws a blank, head on over to this post for a quick review of the SYSVOL migration process.

Before we begin …

The domain functional level needs to be raised to ‘Windows Server 2008’ domain functional level before SYSVOL migration can commence. Therefore, the first step in the SYSVOL migration process is to upgrade all domain controllers to Windows Server 2008. This can be done in a phased manner. Once all domain controllers have been migrated to Windows Server 2008, the domain administrator is ready to raise the domain functional level to ‘Windows Server 2008’ domain functional level.

In order to raise the domain functional level to ‘Windows Server 2008’:

a)       Open the ‘Microsoft Management Console‘ (MMC).

b)       Navigate to the ‘File‘ menu and select ‘Add/Remove Snap-in…’.

c)       Add the ‘Active Directory Domains and Trusts‘ snap-in.

d)       Select the domain whose functional level is to be raised from the left hand side pane and select ‘Raise domain functional level‘ from the right click menu.

e)       Select ‘Windows Server 2008‘ from the drop down list and click the ‘Raise‘ button to raise your domain functional level to Windows Server 2008.


Figure 1: Raise the domain functional level to ‘Windows Server 2008’. Continue reading

Advertisements

DFS Step-by-Step Guide for Windows Server 2008


ou can install the DFS components by using the following procedures.

Installing Windows Server 2008 and DFS


During Setup, follow the on-screen prompts to install Windows Server 2008. Refer to the section “Lab Requirements” earlier in this guide for details about which servers must run Windows Server 2008 and which servers can run Windows Server 2003 R2 or Windows Server 2003 SP1.

After Windows Server 2008 is installed, you can install the DFS components and open the DFS Management snap-in by using the following procedures.

Note

The method below using the Server Manager tool enables you to install DFS as a part of the file server role. This method also installs other file server tools, such as File Server Resource Manager and File Server Management.

To install DFS as part of the file server role


  1. Click Start, point to All Programs, point to Administrative Tools, and then click Server Manager.
  2. In the console tree of Server Manager, right-click the Roles node, and then click Add Roles.
  3. Follow the steps in the Add Roles Wizard, and supply the information described in the following table.
Add Roles Wizard page

What to enter

Before You Begin

Click Next after you verify that the requirements listed on the page have been met.

Select Server Roles

Select the File Services check box.

File Services

Click Next.

Select Roles Services

Select the Distributed File System check box to install both DFS Namespaces and DFS Replication.

To install DFS Namespaces or DFS Replication individually, select the check box that corresponds to the part of DFS that you want to install.

Create a DFS Namespace

Select the Create a namespace later using the DFS Management snap-in in Server Manager check box.

Confirmation

Click Install to install the file server role and DFS.

Installation Progress

This page is automatically replaced by the Installation Results page when installation is completed.

Installation Results

Note any errors, and then click Close to close the wizard.

Use the following procedure if the file server role has already been added.

Continue reading